Konica Minolta CM-2600d, Инструкция по эксплуатации

Страница: 85 / 127

E-83
Pass/Fail Judgment for Color Difference
M
emo
• If “PASS/FAIL” has been selected as the display mode, “PASS” will be displayed only when all the items have
passed.
• If “DIFF/ABS” has been selected as the display mode, the values for the items which have failed will be high-
lighted
• If a color difference has not been set, when the target mode is “linked to each data.”, and the target color data
number set at the time of measurement is deleted, “----” appears instead of “PASS/FAIL”.
• If does not appear due to the auto power save function, this may be due the fact that it can take time to
start measurement after
C
is pressed.
Pass/Fail Judgment Based on Elliptical Tolerances
This function is used to judge whether the measured color difference is within the elliptical tolerances specified
for the target color.
To perform pass/fail judgment based on the specified elliptical tolerances, follow the procedure given below:
N
ote
• To use this function, make sure that elliptical tolerances are set.
• “PASS” or “FAIL” is displayed only if “PASS/FAIL” has been selected as the display mode.
[Setting Procedure]
<COND
*
> screen
1
Turn
B
to select “TARGET”, then press
A
.
• “T*” does not appear if “defined in COND.” mode is selected.
2
Turn
B
to select “
D
”, then press
A
.
“
D
” will change to “
E
” .
3
Turn
B
to select the desired target color no. (T
*
), then press
A
.
“
E
” will return to “
D
”.
• Keeping
B
held down to left or right will cause the target color No. to change continuously.