Kongsberg cNODE MiniS, Инструкция по эксплуатации

Страница: 28 / 62

28
397152/E
2 Flush connector interface with fresh water (deionized water if available), remove
all dirt, grit and grease.
3 Inspect for damage in sealing areas, excessive corrosion, debonding of the cable
and connector interface and cuts in the cable jacket.
4 Apply thin film of dilectric compound (DC) grease, silicon based, to sealing areas
of male connector and across the face of the female connector. If the bulkhead
connector (BC) is removed from it’s housing then replace facial o-ring and make
sure that o-rings are lubricated and in good condition. The use of some oil-based
propellants in spray cans can cause conductivity problems in neoprene.
5 Mate the connector halves, wipe away any excess grease off the interface line of
the mated set.
cNODE MiniS Instruction Manual