Kongsberg cNODE Micro, Инструкция по эксплуатации

Страница: 33 / 56

426351/A
31
Safety features
Pressure relief valve
The pressure relief valve prevents internal pressure to build up. This valve will release
the pressure if it exceeds approximately 1.0 bar.
The relief valve will normally pop out gently releasing the pressure. The valve is reset
by firmly pushing the valve back in and is levelled with the surrounding surface.
Resetting the valve can in certain cases be obstructed due to production of acids and salts
leaking from a damaged battery. In such cases the battery and circuits may have been
damaged. Please contact Kongsberg Maritime for assistance.
Charging the battery (on-deck)
The battery is charged through the external connector. This is connected with some risk,
please read the information below and follow the charge procedure carefully.
Prerequisites
Caution
The cNODE Micro with battery must be climatised to a temperature between 10 and
40°C before charging.
For on-deck charging use the cNODE Micro battery charger only.
Never charge the battery unattended.
Make sure the transponder is switched off before charging the battery and that the battery
is climatised to a temperature between 10°C and 40°C before charging it.
Context
Note
Always connect the cNODE battery charger to the cNODE Micro before connecting the
cNODE battery charger to the mains (110 or 220 Vac).
The battery must be fully charged before long term storage and it is recommended to
recharge the battery every 6 months to make sure the battery does not discharge over
time.
Required battery state for transportation is 30% or less remaining capacity to comply
with regulations.
Maintenance