Kongsberg cNODE Embed, Инструкция по эксплуатации, Страница: 13 / 38

429468/B
13
2 Use one red wire (0.5 mm 2 ) and connect the black wire from the transducer with the
red wire from the transformer.
3 Use two black wires (0.5 mm 2 ) and connect both to the black wire from the
transformer.
4 Use two blue wires (0.5 mm 2 ) and connect both to the blue wire from the
transformer.
5 Use two green wires (0.24 mm 2 ) and connect both to the green wire from the
transducer.
6 Use one orange wire (0.24 mm
2
) and connect to the orange wire from the transducer.
7 Add crimp terminals to the end of the wires.
8 Install the crimp terminals in a Molex 8-pin receptacle according to the cable
drawing.
a Connect the green wires to pin 1 and 5 on the receptacle.
b Connect the black wires to pin 3 and 7 on the receptacle.
c Connect the blue wires to pin 4 and 8 on the receptacle.
d Connect the orange wire to pin 6 on the receptacle.
This is now receptacle J1.
9 Connect receptacle J1 to connector P1 on the front of the PCB.
Installing the transducer cables TD80V
The cables can be provided with an optional cable kit.
Prerequisites
Transducer connector pinout J1, page 15
The following specific items are required for this task.
• 1 x Molex 8–pin receptacle 43025-0800
• 7 x Molex Female crimp terminal 43030-0008
Installing the cNODE Embed cables