Koncar L1A 60 391NF.BS, Инструкция пользователя

Страница: 6 / 39

EN - 5 -
• Do not touch frozen goods with wet hands! Do not eat ice-cream and ice
cubes immediately after you have taken them out of the freezer!
• Do not re-freeze the frozen goods after being melted. This may cause
health issues like food poisoning.
• Do not re-freeze frozen goods after they have melted. This may cause health issues
like food poisoning.
• Fix the accessories in the freezer during transportation to prevent damage to
accessories.
• When the door of the freezer is closed, vacuum will occur. Wait for about 1 minute
to reopen it.
Installing and operating your freezer
Before starting to use your freezer, you should pay attention to the following points:
• Operating voltage for your freezer is 220-240 V at 50Hz.
• Mains cord of your freezer has a grounded plug. This plug should be used with a
grounded receptacle that has a 16 ampere fuse minimum. If you don’t have a
receptacle confirming with this, please have it done by a qualified electrician.
• W e do not take the responsibility of the damages that occur due to ungrounded
usage.
• Place your freezer in a place that it would not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, Gas ovens
and heater cores, and should be at least 5 cm away from electrical
ovens.
• Your freezer should never be used outdoors or left under the rain.
• When your freezer is placed next to a deep freezer, there should be at
least 2 cm between them to prevent humidity on the outer surface.
• Do not place anything on your freezer, and install your freezer in a suitable place so
that at least 15 cm is available on the upper side.
• The adjustable front legs should be adjusted to make sure your appliance is level
and stable. You can adjust the legs by turning them clockwise (or in the opposite
direction). This should be done before placing food in the freezer.
• Before using your freezer, wipe all parts back with warm water added with a tea
spoonful of sodium bicarbonate, and then rinse with clean water and dry. Place all
parts after cleaning.
• Install the plastic distance guide (the part with black vanes at the
rear) by turning it 90° as shown in the figure to prevent the
condenser from touching the wall.
• Freezer should be placed against a wall with a free distance not
exceeding 75 mm.