Troubleshooting
1. If the power supply indicator doesn't light up and the laser doesn't work, please
check the power supply, the input voltage and the fuse.
2. In Stand-Alone operation, if the power supply indicator is light up and sound
active indicator isn't light up, but the laser is shut off doesn't work.
A. Because sound is too small make for laser shut off in sound active, please
increase the music volume or increase audio sensitivity with sensitivity knob,
please check as below.
B. Please check if unit has been set up in slave mode, then set up in master mode.
3. In Master-Slave operation, slave unit don't function, please check as below.
A. Make sure to there's only one master in the chain, and the others are set in slave mode.
B. Make sure to control the unit without DMX console controlling.
C. Make sure to take a good quality power cable and connection.
4. In DMX mode operation, the laser is OFF and the DMX signal indicator is
unlighted, please check as below.
A. Make sure to set up the DMX mode.
B. Make sure to have a good connection.
5. In DMX operation, the unit can’t be controlled by the DMX console, but the DMX signal
indicator is flashing, please make sure the DMX console and unit have the same channel.
6. If the unit is fail, please turn off the unit, then turn on again after 5 minutes.
Warranty Warnings:
1. Damages caused by the disregard of this user manual are not subject to Warranty.
The dealer will not accept liability for any
2. Please consider that unauthorized modifications on the device are forbidden due to
safety reasons. Please note that damages caused by manual modifications on the
device or unauthorized operation by unqualified persons are not subject to warranty.
3. If this device will be operated in any way different to the one described in this
manual, it may suffer damages and the guarantee becomes void. Furthermore, any
other operation may lead to dangers like short-circuit, burns electric shock, etc.
After trying the above solution you still have a problem, please contact your dealer
or our company for service.
Page 2
Page 11
Avoid direct eye exposure to the light source while the fixture is on. Always
disconnect the light from its power source before servicing. Always connect the
light to a grounded circuit to avoid the risk of electrocution.
This product is for indoor use only! Use only in dry locations. Keep this device
away from rain and moisture, excessive heat, humidity and dust. Do not allow
contact with water or any other fluids, or metallic objects.
Make sure there are no
flammable materials close to
the fixture(s) while operating.
Please prevent this light
away from electrical shock
When hanging this fixture, always secure it to a fastening device using a
safety cable (not provided).
Always make sure that you are connecting the light to the proper voltage, as per
the specifications in this manual or on the product's sticker. Never connect the
light to a dimmer pack. Make sure that the power cable is not cracked, crimped or
damaged. Ne
The maximum ambient temperature (Ta) is 104 F (40 C). Do not operate
the fixture at a higher temperature. In case of a serious operating problem,
stop using this product immediately!
Use cleaning tissue to remove the dust absorbed on the external lenses
periodically to optimize light output.
Do not remove or break the warranty label, otherwise it void the
warranty.
Always replace with the exact same type fuse, replacement with anything
other than the specified fuse can cause fire or electric shock and damage
your unit, and will void your manufactures warranty.
There are no serviceable parts in the light. Please have all servicing and
adjustments made by a qualified service engineer.
Don’t throw this product away just as
general trash, please dispose of this
product following the abandon electronic
product regulation in your country.
To protect the environment,
recycle packing material
wherever possible.
Power
110V 240V
Ground