Safety advice
· Please read carefully through this safety advice
before using your fire for the first time. Keep
these advice notes safe and if necessary pass
them on to a third party.
· Open the packaging carefully to avoid damaging
the appliance (e.g. the panorama glass pane).
Keep the packaging safe for transporting the
appliance later (e.g. for refurbishment).
· Check that the appliance has been supplied in
perfect condition. If the appliance is damaged -
do not connect it to the mains.
· Do not use the appliance outside.
· The appliance is not intended for commercial
purposes.
· Never place the appliance near wet rooms or
places where there is moisture (bathroom,
shower, swimming pool etc.).
· Danger of fire! Please ensure that no readily
flammable articles have been put down on the
fire (e.g. clothing).
· Disconnect the appliance from the mains by
pulling out the plug if the appliance is not to be
used for a long period.
· To prevent the cable becoming damaged do not
position it near the front of the fire.
· Do not position the fire directly beneath a mains
wall socket.
· Do not use the fire in conjunction with a
programming unit, a time switch or similar
device. This could result in the danger of fire
if the appliance has been covered or badly
positioned.
Assembly and safety instructions
· Choose a freestanding position for the fire.
There must be a clear safety distance of 1 metre.
· Before operating the fire for the first time, check
that voltage of the mains matches that shown
for the fire.
Operation
The individual heat control settings allow you
to enjoy the use of your fire at all times of the
year. The maximum heat output is 1850 watts.
The appliance has a modern efficient convection
system and achieves a comfortable room tempe-
rature by distributing its heat into the room
through an opening with a protective mesh (on
the front).
The electric fire has three operating switches,
allowing you to enjoy comfort and economy
when using your fire.
Selector switch
:
The selector switch has the following basic
settings:
· OFF
· flame
only
· fan (without heat)
· low heat output (900 watts - one quartz heating
element in use)
· maximum heat output (1850 watts - two quartz
heating elements in use)
Flame appearance knob (brightness control)
:
The KH 1118 creates a remarkably realistic and
convincing range of coal-fire effects. Whether
you prefer a small low flame or a bright blazing
fire, by using the flame appearance knob
to
adjust the light you can set the flame to suit your
individual requirements. Just turn the knob
clockwise until you have the best setting.
Temperature controller
:
The temperature controller only for use when
the selector switch
is set to "maximum heat
output" mode.
Set the temperature controller to "max". Once
the required room temperature is reached, it can
be turned back until a "click" can be heard.
This temperature will be kept almost constant
by the thermostatic control switching on and off
the second quartz heating element.
Replacing light bulbs
Note: To avoid the danger of electric shock be
sure to pull the plug out of the mains socket
before replacing the light bulbs.
To replace the light bulbs you will need a cross-
head screwdriver.
The replacement bulbs are 2 No. 25 W candle
bulbs (E-14).
• Unscrew the two screws (see Fig.
), carefully
remove the glass pane by moving it forwards
and place it down somewhere safe
• Remove the imitation embers insert
by
moving it forwards/upwards towards you
•
You can now replace the light bulbs
Refit the items in reverse order, finally securing
the glass panel by screwing in the two screws.
6
