KOMFI-RIDER Liberty, Руководство пользователя

Страница: 24 / 28

23
16.0 FLASH CODES
Scooter controller internal diagnostics
The diagnostic flash codes for your scooter are designed to help you perform basic
troubleshooting quickly and easily. A diagnostic flash code flashes from the Power light in the
event one of the conditions listed below develops.
FLASH
CODE
FAULT EFFECT
ON THE
SCOOTER
SOLUTION
1 Battery charge is too
low or there is a bad
connection. Scooter
continues
to drive.

Charge batteries.

Check all battery wiring connections.

Contact your service agent.
2 Bad connection to
motor. Scooter
stops
driving.

Check all connections between the motor and controller.
This includes the splitter connections between front and rear
chassis.

Motor may be faulty and need replacing.

Contact your service agent.
3 Wiring short circuit.
Scooter
stops
driving.

This is due to wiring damage and all wiring needs checking.

Contact your service agent.
4 Brake error. Scooter
stops
driving.

Ensure the manual freewheel lever is in the drive position
and restart the scooter.

There is a fault with the magnetic brake or wiring.

Contact your service agent.
5 Controller circuit
protection. Scooter
stops
driving.

The motor or its wiring is faulty causing too much current
tripping controller.

Contact your service agent.
6 Throttle control lever
not at centre position
when switching on
scooter. Scooter
stops
driving.

Put the throttle control lever in the central position, turn the
power off and then turn on again.

Check that the charger is not connected.
7 Throttle Pot error. Scooter
stops
driving.

The Throttle Pot or its wiring could be faulty.

The Speed Pot or its wiring could be faulty.

Contact your service agent.
8 Controller error. Scooter
stops
driving.

Check all wiring connections including main battery
connections.

The controller needs replacing.

Contact your service agent.
9 Brake error. Scooter
stops
driving.

Ensure the manual freewheel lever is in the drive position
and restart the scooter.

The electronic brake has a bad connection or fault. Check
the brake and motor connections including the splitter
connections between front and rear chassis.

Also check the controller connections.

Contact your service agent.
10 Controller error. Scooter
stops
driving.

An excessive voltage has been applied to the controller.
Often this is caused by a poor battery connection. Check the
battery connections.

Contact your service agent.