Thank you for purchasing a Trainwreck
Engineered
TM
Komet
TM
Amplifier.
The Komet
Songwriter
30
is a straightforward and easy to operate amplifier. The goal of
this manual is to help you "
get acquainted
" with your Komet
amplifier, and how to make
use of its many capable sounds.
FRONT CONTROL PANEL LAYOUT
(left to right):
1.
Power Switch
: engages power to amplifier.
2.
Standby Switch
: allow the amplifier to warm up for
60
seconds before engaging the
standby switch to the play position. This action allows for the tubes to heat up to the
proper voltage required for operation and will help prolong the lifespan of your tubes.
3.
Pilot Light
:
illuminates when power switch is in "
On
" position. The pilot light uses a
type
#
47
(6.3 Volt)
light bulb. For bulb replacement, gently turn the jewel lens cap
counterclockwise and remove. Now the bulb is exposed. Using the tips of your
fingers, gently push and turn the bulb counterclockwise, extract bulb and replace.
Note:
Your amplifier will continue to operate with no problem with a shorted bulb or
with no bulb at all.
4.
Bass Control
:
controls low end bass range frequencies.
5.
Volume Control
: adjusts
(clockwise)
the overall level and gain of the amplifier.
6.
Treble Control
:
controls high end treble range frequencies.
7.
Bright Switch
:
Three way selector switch.
Middle
position is off,
Down
position
-
slightly bright,
Up
position
-
most bright.
Note:
the brightness factor of this switch, in
either position of brightness, is subtle. See special note towards end of manual.
8.
Input
Jack
: accepts standard ¼ inch plug. Input impedance is 1 Megohm.
Copyright 1999-2017, Komet
Amplification. Group, L.L.C. May not be reproduced in any form without express written consent from Komet
Amplification.
