Komatsu WA480-8, Руководство по эксплуатации и техническому обслуживанию

Страница: 197 / 440

Display Denotation Explanation Control function
Fault Cycle Switch No signal from cycle switch during
pump running time. The control unit is in the FAULT
mode. The sequence of opera-
tions is stopped.
If the fault message will appear again after the reset, consult your Komatsu distributor.
HANDLE REAR VIEW MONITOR
k k
WARNING
• Never operate any of the switches while traveling. If you do so, there is a danger that you may make
an error in the machine operation, or neglect to watch the travel path ahead for safety, and as a re-
sult cause a serious personal injury.
• The rear view monitor is an supporting aid for checking obstacles in the rear or surroundings. An
image appearing on the monitor is limited.
When backing up the machine, be sure to make a visual check, not relying solely on the monitor.
Never rely solely on the monitor when backing up the machine.
• An image on the rear view monitor does not show an actual distance. Drive the machine slowly,
when backing it up.
• The distortion different from the actual state appears on an image on the rear view monitor.
So, look at the center of the screen as a reference.
When the machine is backed up and rear view monitor (1) is
set in operation, a monitor screen enables the operator to
check the rear for safety.
REMARK
• The screen may be hard to see in the dark place at night,
but it is not a trouble.
The luminance of the rear view monitor can be adjusted
with rear view monitor brightness adjustment switch (2).
For the adjustment method, see “REARVIEW MONITOR
BRIGHTNESS ADJUSTMENT SWITCH (3-95)”.
• Reference line (3) is used for checking the side and rear of
the machine roughly.
For the setting of the rear view monitor, see “REAR VIEW
MONITOR SETTING (3-76)”, and for the setting of refer-
ence line, see “METHOD FOR ADJUSTING REAR VIEW
CAMERA ANGLE (3-175)”.
• Reference line (3) dose not synchronize with steering an-
gle. Reference line (3) does not indicate the actual moving
direction or travel path.
• Intensity or color of the objects may change because of
the automatic adjustment function of the camera.
OPERATION EXPLANATION OF COMPONENTS
3-129