USER MANUAL
Kolster-Brandes MR10 6BE6
Project No. 5052
Retro~Lux
is a trading name of Contrelec Ltd
Page 4
High Wycombe ● Bucks ● England
Tel: +44 (0)1494 526270
Email: [email protected]
Web: www.retro-lux.co.uk
4
Bluetooth Operation
The radio requires an audio signal from a Bluetooth device such as a smartphone, tablet,
laptop or PC. If your device is already paired with an audio device such as headphones or a
hands-free headset you may have to un-pair it first.
Please refer to your device’s instructions to place the unit in scan mode to scan for
Bluetooth devices. With your device in scan mode, turn the volume control up by about
one-third, switch the radio on to standby mode at the power inlet, and then turn on using
the front panel control.
You should hear ‘Bluetooth Mode’ from the radio, and the device named ‘YET-M1’
should appear in the list of available devices on your Bluetooth device. Select ‘YET-M1’
to pair with it and, if prompted, enter ‘0000’ as the code. You should then hear ‘Paired’
from the radio.
Play some audio from your device and you should hear it through the radio. After pairing
for the first time the two devices should pair automatically when you power up the radio
unless you actively disconnect, or un-pair it from your device.
If you have difficulty pairing you may have to turn off the radio at the front panel then turn
on again to initiate the pairing process, and reset your device to scan mode.
The range of the Bluetooth receiver in the radio is about 10 metres. Outside this range you
may experience drop-outs, especially if you are in another room, although reception is
good throughout an average family-sized house.
