Ethernet-Gateway
Configuration
2 Ethernet-Gateway <<NPort 5110>>
2.1 Introduction
The discription refers to the Ethernet-Gateway<<NPort 5110>>of <<Moxa Technologies Ltd>> using
Windows XP.
For configuration of the Ethernet-Gateway please install the programm
<<Npadm_Setup_Ver1.12_Build_09041012.exe>> of the product-CD on your PC.
The mentioned Setup-programm can be find on your product-CD. Just look for:
<<Software\Windows\Npadm_Setup_Ver1.12_Build_09041012\>>. .
Make sure that your operating system meets the minimum requirements for installation.
For further information please check your product-CD: <<Software\Windows\version>>.
You can find the complete manual on the product-CD <<Document\Nport 5100 Series\>>.
2.2 Configuring the Ethernet Gateway
You can choose two ways to configure it:
direct Ethernet connection between the gateway and
PC via CROSS OVER cable
Gateway
Laptop
CROSS OVER - Kabel
RS232
Ethernet-
Verbindung
interfacing via the standard (in-house) network
Laptop
Ethernet-Netzwerk
Gateway
RS232
The descriptions below refer to the
direct
Ethernet
connection
that we recommend
and
they require the
standard
factory
setting for the configuration.
If you would like to reconfigure a machine already that has
already configured, reset all values to the standard
factory
setting.
To load the factory settings, please push the reset-button for
approximately 5 seconds. The “Ready”-LED starts to flash.
You can let go as soon as the LED stops.
You can find the reset button on the machine next to the
Ethernet interface.
Read the instructions in the machine description!
ED_DO_MOXA-5110-B01
8
23.09.2010
