Kollmorgen Digital MMC Control, Руководство по оборудованию

Страница: 67 / 322

Kollmorgen - December 2011 65
MMC Smart Drive Hardware Manual
-
SYSTEM POWER DEVICES
Figure 4-13: Connection Diagram for 3-Phase Line Filter
WARNING
High leakage currents exist in AC line filters. The filters must
be grounded properly before applying power. Filter capaci-
tors retain high voltages after removal. Measure voltages to
determine safe levels prior to handling the equipment. Fail-
ure to do so could result in severe bodily injury.
NOTE
To be able to route the interference currents at low impedance back to
the interference sources, the filter, the power unit, and the contact area
of the motor cable shield must have a junction with the common mount-
ing plate over as wide a surface as possible that has good conductive
properties. The best way to ensure this is to use unpainted zinc-coated
mounting plates.
Table 4-13: Part Numbers for AC Line Filters
Current For Drive
Part
Number
6A, 250V, 1 Phase
Single Phase Versions of:
MMC-SD-0.5-230
MMC-SD-1.0-230
M.1015.6922
Line Reactor
(if necessary)
Power
Unit
PE
PE
PE
1L1
1L2
1L3
Main
Contactor
LINE FILTER
2L1
2L2
2L3
PE L3 L2
L1
1U1
1V1
1W1
SCPD