AKI-CDC-MOD-12T | APPENDIX
Kollmorgen | October 2014
34
9
APPENDIX
This appendix provides information for accessing the HMI service menu and interfacing
an AKI to an AKD PDMM and Programmable Automation Controller (Panel PAC).
9.1
HMI Service Menu
The HMI provides a service setting menu to perform touch calibration, IP settings, self-
tests, and other options. After a project is loaded onto a panel, the service menu is
accessible by following the procedures described below.
1. Apply power to the panel.
2. When the hourglass displays, press a finger on the screen and hold for approximately
20 seconds.
3. Enter a PIN code if the service menu is password protected.
4. The touch calibration screen displays the following message:
“
Tap anywhere on screen or touch calibrate will start in 10 seconds.
”
5. Press finger on screen again to enter the service menu.
The Service Menu displays:
Note:
Additional information about the Service Menu options are available in the
Kollmorgen Visualization Builder (KVB) online help: HMI Panel System Software/Service
Menu
9.2
HMI to PDMM Connection and Programming
Modbus TCP is used to communicate from the Ethernet port of an AKI panel to the X32
connector on the top of an AKD PDMM, also referred to as an Ethernet service port. If the
AKD PDMM is connected to a network, switch, or hub you can have Modbus
communication active at the same time as you are programming the AKD PDMM with
your computer through KAS Integrated Development Environment software (KAS IDE).
This is also appropriate for TCP, HTTP, Profinet, or Ethernet IP communication that also
uses the X32 port and any combination can be active simultaneously.
