AKI-CDA-MOD-07T | SAFETY PRECAUTIONS
•
For Canada also AVERTISSEMENT – AVANT DE DECONNECTER L’EQUIPEMENT, COUPER
LE COURANT OUS’ASSURER QUE L‘EMPLACEMENT EST DESIGNE NON DANGEREUX.
Only UL and cUL approved expansion units are allowed to be connected to the port
designated “EXPANSION”. At the moment there are no such units evaluated or allowed.
Do not replace expansion unit unless power has been switched off or the area is known to
be non-hazardous.
•
This product contains a battery; this must only be changed in an area known to be non-hazardous.
•
Replace the battery with a BR 2032 battery. Use of another type of battery may present a risk of
fire or explosion.
Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.
•
For use on a flat surface of a type 4X enclosure indoor use only.
•
Use 75 degree conductors only
•
Use copper conductors only
•
To make wiring connections to the power supply connector, follow the table with cable and torque
specifications below:
Terminal Block No.
Wire Size AWG
TQ Lb.In.
X1/X100 Phoenix connectors
AWG 30–12
5–7
X1/X100 Anytek connectors
AWG 24–12
3.5
•
These devices are Class 2 supplied programmable controllers (industrial PCs) for the use in
industrial control equipment and are intended to be (front) panel mounted (Type 1 and 4x for
indoor use only).
2.3
During Installation
•
The operator panel is designed for stationary installation on a plane surface, where the following
conditions are fulfilled:
–
no high explosive risks
–
no strong magnetic fields
–
no direct sunlight
–
no large, sudden temperature changes
•
Install the product according to the accompanying installation instructions.
•
Ground the product according to the accompanying installation instructions.
•
Only qualified personnel may install the operator panel.
•
Separate the high voltage, signal and supply cables.
•
Make sure that the voltage and polarity of the power source is correct before connecting the
product to the power outlet.
•
Peripheral equipment must be appropriate for the application and location.
ky
Kollmorgen | July 2013
6
