STEP 1: Assembling the Cage
STEP 2: Assembling the Handle
Remove the R219 Coupler
from inside the R210 Handle
Upper Section and remove both
Allen Key Screws.
Join the two sides of the Coupler and
insert into the R210 Handle Upper Section
so that the hole in the Coupler is aligned
with the hole in the Handle. Insert an
Allen Key Screw in the Handle to secure,
but do not tighten all the way.
Slide the R211 Handle Lower Section over
the exposed coupler so the holes align.
Insert the second Allen Key Screw and
tighten both using Allen Key.
DO NOT OVERTIGHTEN.
The numbered white sticker on the mounting disk helps to indicate the next available slot. Insert one wire (R101) as shown into
slot #1 on the mounting disk. You will hear it click into place.
DO NOT INSERT THE WIRE UPSIDE DOWN.
Being careful not to
miss any slots, continue inserting wires in numeric order until all 60 slots are full. Take the second disk, face the silver section of each
disk towards each other, then insert the other end of the wires into the 60 slots in numeric order. Remove the white stickers and
store the 2 extra wires in case damaged wires need to be replaced in the future.
X
Take the centre tensioning bar and push one end into one of the four slits in the centre of the wire mounting disc.
Repeat on the other wire mounting disc.