KB-062019
2019 Kolibri USA
KCD-1000
Cleaning Procedure
Magnetic (MG) Sensor:
Locate the 2 magnetic sensors, which looks like a small metal bar and are found at the top middle of the bill
track as shown below.
Start Sensor:
Locate the 2-part start sensor as shown below. These pair of sensors are seated in the front part of the unit,
between the 2 rollers.
Note: Several factors can cause a KCD-1000 to not recognize a genuine bill:
- Overly wrinkled, overly creased, and overly worn bills
- Dropping the unit or bumping into the unit during use
- A harsh change in temperature
- Extended period of non-use
- Improper maintenance or lack of preventative maintenance/cleaning
If, after cleaning all sensors, this does not resolve the issue, please see the support section on the Kolibri USA
website at www.kolibriusa.com, or contact Kolibri Support at [email protected]
for further troubleshooting.
