3
INSTALLING THE WINE COOLER
The wine cooler should be installed in accordance with local
electrical code requirements. The wine cooler should also be
placed in a location that is strong enough to support its total weight,
keeping in mind that it will weigh substantially more when fully
loaded than when empty.
Before you plug the wine cooler into a power supply, be sure to let it
stand upright for at least 24 hours to allow the temperature to
acclimate.
UNPACKING THE WINE COOLER
Important Notes:
• Choose a location that has
an ambient temperature
between 60 to 85°F.
Operation outside of this
temperature may result in
lowered efficiency or cause
other adverse effects.
• This unit MUST be installed
indoors in an area protected
from the elements, e.g., wind,
rain, water spray or drips.
• The wine cooler should not
be located next to ovens,
grills or other high heat
sources.
Carefully remove the packaging materials. Remove any shipping
tape and glue from your wine cooler before using. Do not use sharp
instruments, rubbing alcohol, flammable fluids, or abrasive cleaners
to remove tape or glue. These products can damage the surface of
your wine cooler.
IMPORTANT
: Do not remove any safety, warning, or product
information labels from your wine cooler.
TYPE OF INSTALLATION
This wine cooler has been designed for freestanding installation
only. There must be adequate ventilation space around the top,
back and sides of the unit.
FREESTANDING INSTALLATION:
A freestanding installation will allow you to install the wine cooler in
almost any place you desire. You must follow the stated instructions
for electrical requirements, installation clearance and leveling the
wine cooler.
WARNING
:
Do NOT install the wine cooler built-in or behind a
closed cabinet door.
INSTALLATION CLEARANCE REQUIREMENTS
• To ensure proper ventilation, allow at least 5” clearance at the
back, 4
” at top and 4” at sides.
• The wine cooler should be installed on a firm and level surface
that will be able to support the entire weight of a fully loaded unit. It
is important for the wine cooler to be level in order to work properly.
If needed, you can adjust the height of the wine cooler by rotating
the feet. See the
“Leveling the Wine cooler” section on page 4.
• A standard electrical supply (115V only, 60 Hz), properly
grounded in accordance with National Electrical Code and local
codes and ordinances is required.