Koki Holdings Hikoki GP 18DA, Инструкция по эксплуатации

Страница: 10 / 24

10
Switching ON
Switching OFF
Warning
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 15.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Finishing of dies for press working, die casting and
moulding.
○ Finishing of thread cutting dies, tools and other small
parts.
○ Internal grinding of tools and machine parts.
SPECIFICATIONS
Model GP18DA
Voltage 18 V
Rated speed 7000–29000 min –1
Max. Wheel diameter 50 mm
Collet chuck Capacity* 6 mm
Weight**
2.3 kg (BSL1850C)
2.8 kg (BSL36B18)
* This varies depending on the area.
** According to EPTA-Procedure 01/2014
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci fi cations herein are subject to
change without prior notice.
Electronic control
○ Soft start
Reduces recoil against the operator by managing the
number of rotations during startup.
○ Overload protection
This protection feature cuts o ff the power to the motor
in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate causes
of overloading.
After that you can use it again.
○ Overheat protection
This protection feature cuts o ff the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in a
few minutes.
After that you can use it again.
○ Restart prevention function
When the power is still switched on, the tool will not
restart when a battery is installed. This function can be
canceled once the tool is switched o ff .
○ Braking Function
Brake is activated when the switch is turned o ff , stopping
the motor’s rotation.
○ Kickback Protection
The kickback protection feature cuts o ff the power to
the motor and stops the power tool in the event of a
sudden drop in the rotational speed of the wheel during
operation (for example, if the wheel locks during cutting
operation, etc.).
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in
Fig. 3 (on page 2).
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1 )
● Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1 , according to the condition of the charger or the
rechargeable battery.
00Book̲GP18DA̲UK.indb 10 00Book̲GP18DA̲UK.indb 10 2021/03/04 15:38:10 2021/03/04 15:38:10