KOKE HTR-2020, Руководство пользователя

Страница: 5 / 20

5
INSTALLATION PROCEDURES
STEP 1 MATERIAL INSPECTION:
1. Open and inspect all of the materials received.
2. Immediately report any damage or material shortages to Koke Inc.
3. Study all installation instructions and drawings.
4. Determine the proper locations for the signs, controls, truck restraint and
exterior lighting system.
STEP 2 INSTALLATION OF THE TRUCK RESTRAINT:
1. Place restraint box in the center of the door opening.
2. Mark the nine (9) hole positions on the face of the foundation wall.
3. Drill nine (9) 5/8” diameter holes approximately 6” deep.
4. Bolt the restraint box to foundation wall using 5/8” x 5”L anchor bolts
STEP 3 HYDRAULIC CONNECTION TO LEVELER & TRUCK RESTRAINT:
See connection diagram (pg. 7 & 8) for hose routing.
Important notes:
1. Hydraulic system must be clear of debris / dirt particles and all hoses capped/
covered when feeding through the conduit.
2. Drain oil and clean reservoir.
3. Flush hydraulic system.
4. Refill reservoir with new oil.
Failure to do items 1-4 above will cause damage to the unit and void the
warranty.
5. Required hydraulic oil: MOBIL DTE 10 Excel 15 or equivalent.
STEP 4 MOUNTING:
1. Select location and mount the exterior sign and light system as shown on pg.7.
2. Select location and mount the interior control box and sign as shown on pg. 7.
STEP 5 ELECTRIC PROXIMITY SWITCH INSTALLATION TO EXISTING UNIT:
1. Mount the limit switch plate behind the leveler lip.(See diag. on pg 14)
2. The switch plate can be either welded or bolted into place.(See diag. on pg.14)
STEP 6 ADJUST THE PROXIMITY SWITCH LIMIT ON EXISTING UNIT:
(See page 14 for Proximity Switch diagram)
1. Adjust the limit switch within 3/16” of the lip.
(NOTE: lip must be tight against its stop (fully retracted position))