5
113863-5-
CC
Kohler Co., Kohler WI
3. OPERATING INSTRUCTIONS
A. START-UP WHIRLPOOL
Your Kohler Whirlpool Bath promises many hours of
massaging relaxation and enjoyment. Turn on the
whirlpool jets for a vigorous hydro-massage – each jet
can be adjusted individually for optimum air and water
mixture and flow.
Please perform the following so that you may safely
receive the benefits of whirlpool bathing.
To use: Fill your whirlpool bath to a water level 2” to 3”
above the highest jets.
Press the actuator. The whirlpool will operate until:
you press the actuator button again for low-speed
operation. When you press the actuator button a
third time, the pump will shut off.
the whirlpool timer automatically turns off the
whirlpool pump/motor after 20 minutes of
operation.
B. OPERATING SEQUENCE
WARNING: Risk of injury or property damage.
Whirlpool controls are factory installed. Do not
relocate or modify controls as this could adversely
affect safe operation.
Refer to chart for proper operating sequence.
The operating cycle continues as long as the pump and
motor are running. A built-in timer automatically shuts off
the pump and motor after 20 minutes of operation.
Your whirlpool is equipped with a built-in heater. The
heater will automatically cycle on and off to maintain a
maximum 104
°
F (40
°
C) water temperature.
Refer to Important Safety Instructions located on
Page 2 of this manual before operating this
whirlpool.
TO
METHOD
OBSERVE
Turn on high
speed whirlpool
massage (and
the heater, if so
equipped).
Turn on low
speed whirlpool
massage (and
heater, if so
equipped).
To add air and
water to whirlpool
action, rotate
the flange
counterclockwise.
To reduce air and
water, rotate it
clockwise.
Shut off whirlpool.
Restart whirlpool
after 20 minute
cycle is
complete.
Reduce
Air and
Water
Add Air
and
Water
