Kohler WELLINGTON LITE K-3446, Руководство по установке

Страница: 4 / 8

113978-2-
CA
(-)
4
Kohler Co., Kohler WI
TO INSTALL TANK
Make sure the three tank bolts extend completely through
the holes in the gasket. Set the tank onto the bowl, using
the tank bolts as a guide. Center the gasket on the inlet of
the bowl. Assemble the washers and brass nuts onto the
bolts.
Alternately tighten the three brass nuts so the top of the
tank and the top of the bowl are both level. Be sure the
brass nuts are tight enough to achieve a watertight seal.
CAUTION: Risk of product damage:
Overtightening may cause breakage or chipping of
the vitreous china bowl or tank.
Fig. #7
Tank Bolt
Gasket
Washer
Brass Nut
TO CONNECT SUPPLY SHUT-OFF VALVE
NOTICE: Read this section carefully before performing
these steps.
For installation of the supply shut-off valve, refer to the
installation instructions packed with the valve. Carefully
bend the tubing to fit.
Cut the end of the tubing 1/4” longer than the distance be-
tween the supply shut-off valve and the supply shank. Re-
move any burrs from the inside of the tubing.
Slip the coupling nut, compression nut, and ferrule onto
the tubing. Insert the tubing into the supply shut-off valve
and the supply shank, positioning the seal washer
(supplied) or the compression washer (not supplied), as
shown. Hand tighten the coupling nut, and then tighten the
compression nut.
WARNING: Risk of external leakage. The fill
valve nut has been factory-tightened to design
specifications. If re-tightening is required, wrench
tighten one turn past finger tight.
Fig. #8
Tubing
Ferrule
Supply Shank
Seal Washer
Coupling Nut
Compression Nut
Supply Shut-Off Valve
Compression Washer
Tubing
Coupling Nut
Compression Nut
Ferrule