Remove the old gasket from the floor
and closet flange with a putty knife.
Remove the old T-bolts and discard
them.
If the new toilet is not
installed immediately, temporarily stuff
a rag into the closet flange.
NOTICE:
T
Closet Flange
Fig.#2
2
-3-
1007282-2-A
Assemble the bolt cap bases, washer,
and nuts on exposed T-bolts. Hand
tighten the nuts, then tighten them an
additional 1/2-turn.
Overtightening may cause
breakage or chipping of the
vitreous china.
If the T-bolts extend more than 6mm
(1/4") over the top of the nuts, cut off
the excess and file the end. Wipe
away any residue. Install the bolt cap.
CAUTION: Risk of personal
injury or product damage:
T
T
6mm
Fig.#6
6
8mm
T
Install two new 8mm (5/16") diameter
T-bolts into the closet flange.
Do not use white cement or
high lime content cements to install
this toilet. The expansion of cement
due to a rise in temperature may make
the toilet crack or cause damage.
Kohler is not responsible for any
damage caused by installation with the
use of cement.
NOTICE:
TO INSTALL TOILET
K-4349 toilet shown throughout the
instructions.
Set the toilet upside down on some
padding. Firmly press the toilet gasket
onto the toilet outlet.
Wax ring type toilet gasket
should not be installed at temperatures
less than 21
.
If you are using a toilet
gasket with an integral plastic sleeve,
make sure the gasket is positioned
with the sleeve facing away from the
toilet.
If you temporarily plugged the closet
flange with a rag, remove the rag at
this time and ensure that the drain pipe
is clear and free of debris.
Carefully align and lower the toilet over
the closet flange and T-bolts. Apply full
body weight to the toilet rim to set the
seal.
Do not lift or rock the
toilet after placement - a new
toilet gasket must be installed if
you break the watertight seal.
NOTE 1:
NOTE 2:
CAUTION: Risk of external
leakage:
K-4349
1
21
2
Fig.#3
3
T-Bolts
T
Closet Flange
Fig.#5
5
Bottom of Bowl
Toilet Gasket
Closet Flange
T-Bolt
T
Bolt Cap
Nut
Washer
Bolt Cap Base
T-Bolt
T
