-5-
2. This product is not suitable to be installed
outdoors, and shall keep away from ultraviolet
light, heat, fuel, and various chemicals as far
as possible. It shall be protected from frost
crack, so when the ambient temperature is
below 5 , you shall take protective
measures for the filters.
3. When winding the raw material belt, you need
to wind sufficiently and uniformly.
4. When tightening the hexagonal nut with a
wrench, you need to ensure that other
components will not rotate with it.
5. You shall carefully observe for leaks or
leakages after the installation is completed.
6. When installing this device, you shall observe
the right direction of the system water flow!
Make sure that the flow direction in the
pipeline is consistent with the direction of the
arrow on the filter body during the installation.
In all the installation, maintenance and
schematic diagrams in this manual, Toobi 200 is
taken as the example, unless otherwise stated.
The schematic diagram is for reference only,
and please adhere to the actual product instead.
This product is for household pre-filter or water
protection, and is usually installed behind the
main inlet valve or meter (as shown in Figure ).
The following installation instructions take the
installations of PPR pipe connecting road as an
example. If the household water pipes are
connected by metal hard pipes, you need
external detours according to the actual situation.
2.
5
3.
4.
5.
6.
200
(
)
PPR
Fig.
1373811-T01-
B
