1.) This shower arm is designed to be fitted to a G1/2” male supply
fitting located in a hole no bigger than 32mm and below the
finished wall.
2.)
Apply tape or thread sealant to G1/2” threads of the male supply fitting (1).
3.) Install the outlet adaptor(2) onto the supply fitting. Secure it with a wrench
and make it extend 31-40mm beyond the finished wall
(Refer to rough-in
drawing).
INSTALLATION - Outlet adaptor
CLEANING INSTRUCTIONS
1.
Apply a ring of plumbers putty or other sealant to the shower arm base(3).
2.) Install the shower arm onto the outlet adaptor(2). Make sure the setscrew
hole faces downwards. Carefully tighten the setscrew using the hex
wrench(4) provided.
NOTE: Do not overtighten the setscrew
3.) Remove any excess putty.
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with a
clean soft cloth. Many cleaners may contain such chemicals as ammonia, chlorine, toilet chemicals etc. which
could adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler fittings.
INSTALLATION - Shower Arm
1.)
Flush the water supplie lines through the shower arm(3) for about one
minute to remove debris.
2.) Install the screen washer(5) into the shower arm(3).
3.) Apply the appropriate amount of tape or sealant to the shower head(6)
threads.
4.) Tighten the showerhead(6) using a strap wrench.
INSTALLATION - Shower Head
SPARE PARTS
**Color code must be specified when ordering
1138600-AN2-A 04/07/11
3
1138600-AN2-A 04/07/11
2
Shower Arm & Shower Rose
STANCE
SHOWER TAPWARE
Shower Arm & Rose: 14787A
1097029
O-ring
1097028
Washer
1097030-DC
Clamp half
1171829
Adaptor
1088638
Setscrew
1081607
Hex Wrench
1103366**
Shower Arm
77420
Screen Washer
1173460**
Showerhead
O32 Max
5
6
2
1
2
3
3
4
