INSTALLATION
安装
-4-
STEP
1
STEP
2
STEP
3
STEP
4
STEP
5
STEP
6
STEP
8
STEP
7
STEP
9
IMPORTANT:
Tray
MUST
be level
along front edge.
重要：
底盘
必须
水平。
0mm
0mm
6mm
0mm
外门玻
内门玻
Mount the handle
安装拉手
Level the weather bar. Mark the wall 5mm in from the front edge of
the tray.
档水条打水平。从挡水台边缘向内偏
5mm
。
Install the panel glass and the center post.
安装固玻及中柱。
Install the handle and the top cover.
安装拉手以及顶盖。
Install the seal
安装胶条
Adjust the position of the
bumper block or stopper
调节防撞块或定位锁块位置
Adjust the height of the door glass
properly
Snap in the decorative cap for the pulley
调节门玻到合适的高度后卡入吊轮装饰盖
Adjust.
调节。
Apply glass cement.
打玻璃胶。
Install the top rail.
安装上导轨。
Install the door glass. Note: The external door glass should be hung
from the inside to the outside and the internal door glass should be
hung from the outside to the inside. Both should be carried out at the
inner side of the rail.
安装门玻。注意：外门玻在导轨内从内往外挂，内门玻在导轨内从外往
内挂。
Outside
淋浴房外侧
Outside
淋浴房外
Outside
淋浴房外
Decorative cap
facing outward
装饰盖朝外
Decorative cap
facing inward
装饰盖朝内
Inside
淋浴房内
External
door glass
外门玻
Internal
door glass
内门玻
Inside
淋浴房内
Inside
淋浴房内侧
The wall jamb
must
be kept vertical.
上墙材
必须
垂直。
The wall jamb
must
be kept vertical.
上墙材
必须
垂直。
Draw the installation holes. Place the bottom rail at the proper position.
Make it flat. Snap the two wall jambs into the rail successively. Mark
and drill the holes into the wall. Pay particular attention to the
orientation of the wall jambs to be installed (see the enlarged figure).
画上墙孔。先摆好下导轨，打好水平后先后将两支墙材从上往下卡入下
导轨，描好定位孔后再往墙上打孔。特别注意墙材的内外方向（见放大
图）。
Fix the wall jambs. Snap two jambs into the bottom rail from the top
and then fix them onto the wall with screws.
固定上墙材。分别将两支墙材从上往下卡入下导轨后用上墙螺丝固定在
墙上。
1372200-T01-A
