1.) This spout is designed to be fitted onto a G1/2" male fitting(1)
that protrudes out from the finished wall minimum of 15mm.
The wall hole is to be no bigger than 32mm in diameter.
2.) Apply tape or thread sealant to the G 1/2" male fitting.
3.) Assemble the spout kit(3) to the escutcheon(2) by
aligning the spout pins with the escutcheon holes.
4.) Put the washer(4) into the groove on the bottom of the
escutcheon(2)
5.) Thread the spout assembly securely onto the G1/2" fitting.
Align the spout to be facing downward into the tub.
Note: Be careful not to scratch the surface of the finished wall
during install.
6.) Remove any excess putty or sealant.
INSTALLATION - Spout
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with a
clean soft cloth. Many cleaners may contain such chemicals as ammonia, chlorine, toilet chemicals etc.
which could adversely affect the finish and are not recommended for cleaning.
SPARE PARTS
**Color code must be specified when ordering
1142969-AN2-A 15/10/12
3
1142969-AN2-A 15/10/12
2
Wall Mount Bath Spout
SINGULIER
BATH TAPWARE
Wall Mount Bath Spout: 8161A
O32 Max
1
1.)
Ensure that all connections are tightened.
2.)
Remove the aerator assembly(5).
3.) Open the drain. Run water through the spout for about a
minute to remove any debris and check for leaks at this time.
Repair as required.
5.)
Remove any debris from the aerator assembly and reinstall the aerator assembly.
INSTALLATION CHECKOUT
2
4
3
5
1142934
Washer
1141070**
Escutcheon
871009
O-ring
834562**
Aerator
