INSTALLATION - Spout
INSTALLATION CHECKOUT
2
3
1221392-AN2-A 27/05/2016
1221392-AN2-A 27/05/2016
NOTE: The installer must provide a G1/2” male supply fitting(1),
that protrudes out 35-50mm from the finished wall .
1.) Apply thread sealant to the thread of the G1/2” male fitting.
2.) Stick the sticker washer(2) onto the wall side of the
escutcheon(3).
3.) Slide the escutcheon onto the spout(4) and thread the
spout onto the male fitting. Tighten using a strap wrench
and adjust the spout so that it faces downwards.
4.) Slide the escutcheon up to the finished wall and make sure
the sticker washer adheres to the wall.
1.) Ensure that all connections are tightened.
2.) Remove the aerator kit(5) and run hot and cold water through the spout
for about one minute to remove any debris. Check for leaks at this time.
3.) Turn off the water supply and remove any debris from the aerator kit.
4.) Reinstall the aerator kit.
1
**Color code must be specified when ordering
Bath Spout - Wall Mount
PURIST
BATH TAPWARE
Bath spout - Wall mount: 14426A
SPARE PARTS
35-50mm
Finished wall
2
3
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with a
clean soft cloth. Many cleaners may contain such chemicals as ammonia, chlorine, toilet chemicals etc. which
could adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler fittings.
O-ring
Escutcheon
Aerator Kit
Sticker washer
1066678**
21271
1012717**
1015726
4
5
