Kohler PowerWAVE 8000DPA RI (S2) Series, Руководство пользователя, Страница: 56 / 88

4: Installation
48
TS_616_08 PW8000DPA ST (S2) User Manual 21/4/22
4.3 Unpacking
4.3.1 Removing the standard UPS packaging (cardboard container)
THIS NEEDS THOUROUGH CHECKING
The outer packaging of ST-40 and ST-80 models comprises a cardboard sleeve
with a folded top cover, as shown in Figure 4.2. A cardboard sleeve and separate
top cover is used as the outer packing for the taller ST-60, ST-120 and ST-200
models. The top cover is held in place by two plastic straps as shown in Figure 4.3.
Perform the following steps to unpack the UPS equipment from the standard
packaging:
1. Open the packaging top cover (after cutting the two plastic straps where
applicable).
2. Carefully remove the accessories box that is shipped on top of the main UPS
cabinet. [Confirm that this is not also wrapped in the plastic shhe, which my be
removed first]
The standard accessory box contents are: user manual, 2x painted kick-plates,
screws, 4x adjustable feet and keys.
3. Remove the cardboard sleeve by pulling it towards the top of the cabinet.
4. Remove any cardboard or polystyrene fillets that are taped to the outside of the
plastic wrapping.
5. Remove the plastic wrapping by pulling it upwards over the top of the cabinet.
Note: The edges of the cabinet are not protected, so if you have to cut the
wrapping take care not to scratch or damage the cabinet paintwork.
6. Remove the four screws securing the pallet to the cabinet legs, as indicated in
Figure 4.4.
7. Using a forklift or pallet jack, raise the cabinet clear of the ground.
a) Remove the pallet.
b) Fit the four adjustable levelling feet,
found in the accessories package, to
the bottom of the cabinet legs.
8. Open the cabinet door, remove any
further internal packaging where
applicable and inspect for internal
damage. Report any damage to the
shipper immediately
9. If no damage is found, move the cabinet
to its final location and adjust the levelling
feet as necessary.
10. Fit the painted front and back kick plates,
found in the accessories package, as
required.
QUESTION: The illustration shows that with
the pallet attached the forks are inserted
under the sides of the cabinet. When the
pallet is removed can the forks be inserted
under the front/rear of that cabinet (I don’t
know how the cabinet is constructed!)
Key Point: Remove all packaging materials carefully, causing as little damage as possible, and temporarily
store them in case the UPS has to returned to the manufacturer for any reason prior to commissioning.
Figure 4.3 ST-60, ST-120, 200
packaging
Figure 4.4 Pallet removal