background image

1433620-T01-A

-3-

Top Clip

顶扣

Cabinet

柜体

Mounting Bar

托条

Side Adjustment

调节侧面

Depth Adjustment

调节深度

Height Adjustment

调节高度

Storage Plate

置物板

Hanger

挂架

Storage Plate

置物板

Hair Dryer 

Holder

吹风机支架

Installation of all parts of the mirror cabinet:

镜柜各部件安装说明:

1.  Hang the hair dyer holder and the hanger on the storage plate.

1.

  安装需要将吹风机支架,挂架挂在置物板上。

2.  Small iron tools can be attached to the magnetic chuck on the 

front side of the storage plate.

2. 

小的铁质工具可吸附于置物板正面的磁性吸盘。

Put the mirror to the side mirror bracket. 

Slide the water pan assembly into the slot and push to the rightmost. 

It is recommended to drain the condensed water in the water pan 

once a week.

For detailed operating instructions, please refer to 

the OPERATION INSTRUCTIONS of the refrigerator.

把镜子粘贴在侧镜支架上;

接水盘组件滑进卡槽后推至最右侧,

建议接水盘每周清理一次冷凝水。

冰箱详细操作见冰箱说明书。

1. Put the cabinet on the mounting bar.

1. 

将柜体放在托条上。

2. Insert top clips from the center of the top. Slide the clips to align 

with the drilled holes. Fix with screws.

2. 

从中间缺口嵌入顶扣在柜顶,滑动顶扣,对准上一步骤的钻孔后,用

螺钉固定。

Fix the cabinet

固定柜体

STEP

3

STEP

4

STEP

5

STEP

6

STEP

7

Door adjustments

门的拆装及调整

Adjust the door (only necessary if the door does not completely 
match the cabinet when it is closed).

调门体(当关门时门体和柜体不完全重合时,才需要调节)。

1. Open hinge cover before adjusting the door.

1. 

门体调节前,先将铰链盖揭开。

2. Adjust the hinge of door in 3 directions to make sure the door 

level as shown.

2.

 门板的三向调节。

Install glass shelf

装玻璃层板

1.  Insert the snap-in pins into the side holes.

1. 

将嵌入式层板架插入两边侧孔。

2.  Insert the glass shelf into the snap-in pins. As shown in the left 

illustration.

2. 

将玻璃层板插入层板架。如下图安装方式一。

3.  In case the door opening angle is not enough, insert the glass shelf 

vertically upwards and then rotate to horizontal position, as shown 

in the right illustration.

3. 

如果门打开角度较小,按安装方式一不好装玻璃层板时,可按安装方

式二,垂直往上穿入,再旋转水平后推入。

Method One

安装方式一

Method Two

安装方式二

Adjust magnifying glass.

调整放大镜

The mirror can be removed.

放大镜可以拆卸。

Direction

方向

Press the button to easily 

move mirror up or down

按住此按钮可轻松上下移动

放大镜组件

To adjust mirror height, slide up or down.

IMPORTANT! 

Rotate mirror in before closing the door.

上下滑动,以调节镜子高度。

重要:

必须在柜门关闭前旋入镜子。

Install accessories and side mirror as shown.

镜柜配件及侧镜的安装:按图示位置进行按装。

Содержание MAXISPACE 2.0

Страница 1: ...本产品符合 GB 24977 2010 GB 7000 201 2008 GB 7000 1 2007 GB 17743 2007 GB 17625 1 2012 GB T 17743 2017 GB 19510 1 2009 GB 19510 14 2009 ZHONGSHAN KOHLER SHOWER CO LTD NO13 1 XINGYE ROAD ZHONGSHAN TORCH DEVELOPMENT ZONE ZHONGSHAN GUANGDONG CHINA POST CODE 528437 中山科勒卫浴有限公司 广东省中山市中山火炬开发区兴业路 13 1 号 邮编 528437 Copyright Kohler China Investment Co Ltd 2020 版权为科勒 中国 投资有限公司所有 2020 1433620 T01 A 1 WARNING Risk ...

Страница 2: ... or4 Ø 6 holes on the wall as shown The holes on the same line shall keep level 在墙上钻5个 或4个 Ø 6孔 尺寸如下图所示 注意同一排孔保持水平 Item 序号 Electrical Function 电器功能 Type Descripetion 规格描述 Fixate Place 安装位置 1 Power 电源 Input 220V 50Hz Pmax 36W Top of Cabinet 柜体顶部 2 Power 冰箱适配器 Input 220V 50Hz Pmax 60W Top or right of cabinet 柜体顶部或右边 3 Fridge 冰箱 Input 220V 50Hz Pmax 50W Right of inner cabinet 柜内右部 4 Defoger 防雾膜 Input...

Страница 3: ...缺口嵌入顶扣在柜顶 滑动顶扣 对准上一步骤的钻孔后 用 螺钉固定 Fix the cabinet 固定柜体 STEP 3 STEP 4 STEP 5 STEP 6 STEP 7 Door adjustments 门的拆装及调整 Adjust the door only necessary if the door does not completely match the cabinet when it is closed 调门体 当关门时门体和柜体不完全重合时 才需要调节 1 Open hinge cover before adjusting the door 1 门体调节前 先将铰链盖揭开 2 Adjust the hinge of door in 3 directions to make sure the door level as shown 2 门板的三向调节 Install gl...

Страница 4: ...rd 接好电源线后 把助推把手掰下来 用螺丝把顶盖固定在镜柜顶部 Note 1 LED light and defogger will be controled by the inductive switch 2 Power of the electrical equipments connected to the socket shall not exceed 2000W 注 1 通过手扫开关控制灯和防雾膜 2 电源插座外接电器总功率不能超过2000W Connect to Power Line Three Core Cable 外部电源输入线 三芯电缆线 220V 50Hz The leads of the power adapter have been connected at the factory 电源适配器引线出厂时已经接好 The leads of the power soc...

Отзывы: