All information is based on the latest product information available at the time of publication. Kohler Co.
reserves the right to make changes in product characteristics, packaging, or availability at any time without
notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. The installer must provide a G1/2” male supply fitting(1), protruding 15mm out from the face of the
finished wall.
2. Flush the water supply pipes thoroughly to remove any debris.
3. An in line water filter must be used with this product.
4. Inspect the supply pipes for damage. Replace as necessary.
5. Observe local plumbing codes.
6.
Check for leaks before covering the pipes, repair as needed.
7. Recommended working pressure: 100 to 500kPa.
8. Maximum working pressure: 800kPa.
9. All installations should comply with the relevant requirements of AS/NZS 3500.
BEFORE YOU BEGIN
ROUGH-IN DIMENSIONS
1
1154542-AN2-B 12/04/2016
Bath Spout - Wall Mount
LOURE
BATH TAPWARE
Bath spout - Wall mount: 14676A
INSTALLATION INSTRUCTIONS
The finished wall
Fringe of bath
160
50
88
121
G 1/2"
243
19
