INSTALLATION
4 5
(LR06×4)
220V
50/60Hz
0.75
0.5
～
1
0.1MPa
2.0L/min
1
1
～
55°C
0.5
～
71°C
0.05
～
0.86MPa
PARAMETERS
Power: DC 4 pieces of AA size alkaline batteries
AC 220V, 50/60Hz
Senser Duration: Less than 0.75s
Shut-off Delay: 0.5~1s
Sensing Distance: Automatic adjustment
Flow Rate: No more than 2.0L/min at 0.1MPa.
Overtime Flowing Control: Automatically stop flushing when
the faucet senses an object for more than 1 minute
continuously
Ambient Temperature: 1~55°C
Supply Water Temperature: 0.5~71°C
Supply Water Pressure: 0.05~0.86MPa
2. Fasten control valve assembly
Unscrew valve cover screws (11) by
screwdriver, open valve cover (10).
Determine control box assembly (9)
installation location per rough-in; then
drill holes, and punch plastic expansion
tube (12) in. Place valve box against
the wall and then mount control valve
assembly on the wall by expansion
screws (13). Keep control box assembly
parallel to the wall.
9
11
10
13
12
2.
控制阀组件的安装固定
拧松
11
10
9
12
13
4
1495647-T2
-A
2
1
4
3
6
5
7
8
如何安装水龙头
一 龙头与面盆的安装固定
将固定螺杆
(2)
安装到水龙头
(1)
底部
处。再把垫片
(3)
套在固定螺杆上。
并嵌入水龙头底部的盘槽中。然后
将电源线(7)和进水软管
(8)
穿过安
装孔，从面盆下方将固定橡胶垫片
(4)
固定金属垫片
(5)
和固定螺母
(6)
对齐固定螺杆向上套入。调整水龙
头电源线及进水软管的位置。用扳
手拧紧固定螺母以便把水龙头固定
在面盆上。
How to Install the Faucet
1.
Secure
faucet on lavatory
Install the stud (2) to the underside of the
faucet (1). Slide the gasket (3) over the
stud, and then seat the gasket in the groove
on the underside of the sprout. Cross power
cord (7) and water inlet hose (8) through
mounting hole, slide rubber washer (4),
metal washer (5) and nut (6) onto the stud
from under the sink. Adjust faucet power
cord and water inlet hose position, fasten nut
to secure faucet on lavatory mounting
surface by wrench.
