Care and Cleaning
Flush the System
NOTE :
To restore dull or scratched units : Apply white automotive polishing compound with a clean rag. Rub scratches
and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not wax areas
where you walk or stand.
Use a mild detergent such as liquid dishwashing soap and warm water for cleaning. Do not use abrasive
cleaners that may scratch or dull the surface.
Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.
Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
Do not allow cleaners to sit or soak on the surface.
Wipe surfaces clean and rinse completely with water immediately after cleaner application. Rinse and dry
any overspray that lands on nearby surfaces.
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to
clean surfaces.
Cleaning Your User Keypad
Use a soft cloth to wipe the keypad after each use. If the surface becomes dirty, use a non-abrasive soap and warm
water to clean.
Flush your whirlpool system twice a month or more, depending upon usage.
Fill the bath
with warm water
to a level above the top of the higher jet around 50 mm
, or leave water in the bath
after using.
Add 2 teaspoons of a low-foaming, powder automatic dishwashing detergent and 20 ounces of household
bleach (5% to 6% sodium hypochlorite) to the water.
Run the whirlpool for 5 to 10 minutes. Then shut off the whirlpool and drain the water.
If desired, rinse baths surfaces with water and use a soft cloth to wipe the product dry.
Clean-Up After Installation
Clean the area around the blower motor of all dust and debris.
Use warm water and a liquid detergent to clean the surface of the bath with airjets.
Do not use abrasive
cleansers
, as they may scratch and dull the surface.
Do not use powdered cleaners unless the cleaner is
fully dissolved in water.
Solid substances could block the airjets.
Do not use bleach or ammonia cleaning
solutions.
Chemically active cleaning solutions can damage the bath surface. Refer to the Care and cleaning
for normal cleaning recommendations.
1334405-EM2-A 10
Kohler Co.
