2. Install the Spout
IMPORTANT!
Keep the diverter body and tube clean to avoid
damage to the O-ring seal.
Install the lift rod into the threaded rod in the diverter body.
Make sure that the lift rod bottoms out against the threaded rod.
It may be necessary to lift up and hold the diverter body’s
threaded rod with a pair of pliers during this install.
Install the diverter tube over the lift rod into the diverter body.
Loosen the spout setscrew until it is clear of the inside wall of the
spout.
Apply a ring of plumbers putty or other sealant around the
underside of the spout base according to the manufacturer’s
instructions.
Position the spout over the lift rod, diverter tube, and diverter
body. Carefully press down until the spout contacts the finished
deck.
Rotate the spout until it is aligned to face straight forward.
Tighten the setscrew.
Make sure the O-ring is in place on the base of the plug button
and push the plug button into place over the setscrew.
Install the lift knob onto the lift rod.
Remove any excess putty or sealant.
Diverter Body
Diverter Tube
Spout Assembly
Setscrew
O-Ring
Plug Button
Lift Rod
Lift Knob
Finished Deck
1054811-2-A
4
Kohler Co.
