-6-
As shown, install the light about 25mm over the mirrored cabinet.
25mm
Fig.9
9
STEP
1
STEP
1
!
!
Wire connection of defogger(Fig.A)
A
1. Open the wire box and pull out the terminal block.
2. Connect to 220V/50Hz power supply. The brown wire is connected with L line and blue wire is connected with N line.
220V/50Hz
3. Put the terminal block back after connecting the power lines and then close the wire box.
4. It is suggested to arrange the defogger switch at the bathroom door and the share the same switch with bathroom
lighting.
Wire connection of lighting(Fig.B)
1. Make sure the positive and negative wires are correctly connected. It is suggested to wipe the joint with electrical
insulation tape.
2. Connect to 220V/50Hz power supply. The brown wire is connected with L line and blue wire is connected with N line.
LED
220V/50Hz
3. The lighting flashes at stand-by mode. Touch the three buttons to switch on and adjust the lighting.
Fig.10
10
INSTALLATION OF LIGHTING
INSTALLATION OF LIGHTING
CONNECT TO POWER LINE
CONNECT TO POWER LINE
A
B
B
A
Defogger Input
Power Input
220V/50Hz
LED Power Supply
LED
1240482-T01-B
