Kohler Co.
7
1082081-X2-A
10.
Tighten panel with flush valve with 4 pcs of long screws.
a. Put on clean gloves during installation to avoid surface
damage.
b. Do not face the side with letters inwards or install in
a reverse way.
USER’S GUIDE
NOTICE:
The first 10 minutes with power is the standby time for adjusting sensing distance. Persons or subjects
should avoid standing before the sensor. The sensor will not flush during this time.
Eco-friendly flush mode
: When the urinal is not used for a long term, it is set to flush with large volume
of water automatically every 24 hours.
Set Working Status:
The product comes our factory with:
1. The working status is set as dual-flush. If you want to cancel the first flushing function, place manual flush
stick adjacent to right side of sensing window for more than 1 second during the 10-minute standby period
(human presence in sensing range would cause the indicator to flash fast). The sensor would generate a
flushing cycle to indicate the setup of the sensor has been adjusted to after-use flushing. If the action is not
completed during this 10 minute, or you need to restore the working status to dual-flush, plug off the power
cord and reconnect the power supply until the indicator stops flashing and repeat the above procedures.
2. The diction time is set as 2s to avoid improper function in narrow toilets, the detection time is automatically set
from 2s to 5s.
Working Status:
Before powering the system on, clear the unwanted objects in front of the sensor window
lest shortening the sensing distance.
Sensing Distance:
During the first 10 minutes, when powered on, the system is in the phase of automatic
regulation, and no operation is required.
Deodorizing Flushing:
The urinal will take a flush automatically when it’s used 3 or 4 times in 2 minutes.
Adjusting Screw
Hex Wrench
Long Screw M4 x 50
Flushing
Volume
: If you need to regulate the flushing
volume, you can take off the cover and turn the adjusting
screw in the center of the stop valve to a proper place.
Manual Flushing:
Approach the supplied special
magnetic stick (flushing control stick) to the middle part
of the sensor lens. The system is now at manual status and
the indicator will flash every 1 seconds. Approach the
flushing control stick to the window,it’ll start to flush;
approach again, stopping flushing.This status will last
for 8 minutes until it turns to the normal working status.
(The flushing, if any, will be terminated when this status ends).
NOTICE:
The longest flusing time is 30 seconds once. If the
flushing control stick keeps near to the sensing window,
the manual status will be terminated automatically and
reassume the normal working status.
Flushing control stick
