-3-
Insert the drain stopper into the drain ell. Adjust drain
stopper to make end of lift toggle assembly near to but
not touch the top of the drain tube, as shown. To adjust
the stopper height, remove the stopper and loosen the
nut below the stopper. Raise the stopper by turning
counterclockwise, or lower by turning clockwise.
Drain Tube
Drain Stopper
Lift Toggle Assy.
Lift Toggle Assy.
Fig.#4
4
Fig.#6
6
FOR VERTICAL DRAINAGE INSTALLATIONS:
Assemble parts as shown. Align the parts with the tee,
as shown. Insert the tubes into the tee. Align and
tighten the nuts.
Attach the tail piece to the tee, and tighten. The tail
piece may need to be cut for proper fit. Install the bath
according to the manufacturer’s installation
instructions. Make sure the drain tail piece fits properly
into the trap.
T
T
T
Tube
Cone Washer
Tee
T
Drain Ell
Nuts
Attach the gasket to the overflow ell, as shown. Make
sure the tapered end of the gasket is facing up. Apply
silicon sealant.
Put the gasket onto O-rings which on the over flow ell and
lubricate them, and insert the overflow ell into the tube.
Align the overflow ell with the overflow hole in the bath.
O
O
Gasket
Fig.#5
5
Tube
Overflow Ell
Apply Silicon
Sealant
Tail Piece
1072366-T01-E
