Kohler K-5401X, Руководство для владельцев жилья

Страница: 8 / 48

1226975-X5-B 8 Kohler Co.
M - Effuser movement
Under Front or Rear mode, press this key to adjust moving position of effuser.
N - Dryer
After sitting, press it once to turn on the dryer function. Press it again to adjust dryer gears. After 4 minutes or
so, it stops automatically or press the Stop key to turn it off immediately.
O - UV
Under non-seating status , short press this key to enter UV sterilization function. And the icon will flicker.
P - Pressure
Under Front or Rear mode, press this key to adjust gears of water pressure.
Guide on Usage of Remote Controller (Cont.)
Low Voltage Alarm
Matching
Communication Between Remote Control And Main Unit
Guide on Setting of the Remote Control
UV
B
G
H
D C
I
J
F
N
O
E
P
M L K
Cover
Stop
Water temp Messagep Spiral Wand Pressure
Front Rear Dryer Clean
Seat Flush-eco Flush-full Seat temp
A
CAUTION: Risk of property damage. Please charge in time when the voltage alarm is activated.
CAUTION: Risk of property damage. Matching can be done only under non-seating status.
When the button flickers, it indicates that the built-in battery in the remote control is used up. Put the
controller on the base to charge its battery;
¨
When the cover is powered on normally, press the Start key at the top of the remote control. When the icon of
the lowest row flickers for a long time, it means the remote control needs to be matched with the main unit.
¨
Long press the Dryer key. When the icon at the lowest row flickers, start the operation at the main unit end.
¨
Meanwhile long press the key and key at side keyboard. Do not release the key until hearing a short
ring.
¨
Once the icon at the lowest row of remote control stops flickering, it means it has been matched successfully.
¨
If the remote control is moved away from the sensing area, the icon at the bottom row of remote control will
flicker automatically (indicating a searching the signal for the main unit). After getting back nearby the main
unit, the signal will be connected automatically if the main unit is under normal power condition. Then the
icon will stop flickering once it is connected successfully.
¨
Long press the key at any time, the remote controller will enter Power off mode.
Poweroff Function