Holder
ᬃᶊᴀԧ
Screw
Tray
㶎ϱ
ᢪⲬ
A
B
150
190
75
B
Holder
ᬃᶊᴀԧ
Screw
㶎ϱ
Tray
ᢪⲬ
Kohler Co.
Record your model number: __________________________
1503912-T2-
A
1
1
2
3
4
5
6
7
8
9
10
1503912-T2
All information is based on the latest product information available at the
time of publication. Kohler Co. reserves the right to make changes in product
characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important
information.
NOTE:
These products should be located and mounted to a wall. While it is possible
to mount them to any surface, a stud, concrete and drywall mounted product
will yield the best results.
DANGER: (Risk of personal injury )
These products are not designed or intended for use as a grab bar or support
bar. Do not install any of these products in any area where they are likely to
be used inadvertently as a grab bar or support bar.
INSTALLATION INSTRUCTIONS
TP HOLDER (W/ TRAY)
K-29221T-**/K-29222T-**/ K-29223T-**/ K-29227T-**/ K-29228T-**/ K-29231T-**
DOUBLE TP HOLDER (W/ TRAY)
K-29224T-**/K-29225T-**/ K-29226T-**/ K-29229T-**/ K-29230T-**/ K-29232T-**
Follow all local plumbing and building codes.
1
. Drill bit
2A
. TP HOLDER (WITH TRAY): Using the provided screw, secure the holder
to the tray with a screw driver.
3B
. DOUBLE TP HOLDER (WITH TRAY): Using the provided screw, secure
the holder to the tray with a screw driver.
4
. Position the tray on the wall and mark the hole points for drilling.
5
. Drill diameter 3mm holes to install on stud, 8mm holes for drywall and
6mm holes for concrete wall.
6
. No plugs are required, when mounted to a wood-panel wall.
6A
. Installation of butterfly anchors to drywall.
Hold the butterfly anchor and fold the edges inside, insert the butterfly anchor
into the drilled hole, stretch it with pin and tap with hammer until it flush
with the wall.
7B
. Installation wall anchor to Concrete wall: Install wall anchors into the hole
and tap with hammer until it flush with the wall.
8
. Use the screws provided in the accessory kit to secure the tissue holder to
the wall through the retaining ring.
9
. Secure the cover on the ring by screwing on top of the ring.
ROUGH-IN (Unit: mm).
10
. K-29221T-**/K-29222T-**/K-29223T-**
