One-Year Limited Warranty
KOHLER plumbing products are warranted to be free of defects in material and workmanship for one year
from date of installation.
Kohler Co. will, at its election, repair, replace or make appropriate adjustment where Kohler Co. inspection
discloses any such defects occurring in normal usage within one (1) year after installation. Kohler Co. is not
responsible for removal or installation costs. Use of in-tank toilet cleaners will void the warranty.
To obtain warranty service contact Kohler Co. either through your Dealer, Plumbing Contractor, Home
Center or E-tailer, or by writing Kohler Co., Attn.: Customer Service Department, 444 Highland Drive,
Kohler, WI 53044, USA, or by calling 1-800-4-KOHLER from within the USA, 1-800-964-5590 from within
Canada and 001-877-680-1310 from within Mexico.
Implied warranties including that of merchantability and fitness for a particular purpose are expressly
limited in duration to the duration of this warranty. Kohler Co. and/or seller disclaims any liability for
special, incidental or consequential damages.
Some states/provinces do not allow limitations on how long an implied warranty lasts, or the exclusion or
limitation of special, incidental or consequential damages so these limitations and exclusions may not apply
to you. This warranty gives you specific legal rights. You may also have other rights which vary from
state/province to state/province.
This is Kohler Co.’s exclusive written warranty.
Troubleshooting Procedures
This troubleshooting guide is for general aid only. For warranty service, contact your dealer or wholesale
distributor.
Symptoms
Probable Cause
Recommended Action
1.
All lights do not
work.
A.
Power is not being drawn from
the outlet.
A.
Plug the cord into the 110 V AC
outlet.
B.
Power is not being drawn from
the outlet.
B.
Verify the outlet is a 110 V AC
outlet.
C.
Wires are improperly connected.
C.
Access the wiring to verify the
wiring is correct.
D.
Circuit breaker has been tripped.
D.
Reset the circuit breaker.
2.
Both LED lights do
not illuminate.
A.
Capacitive switch module is not
powered.
A.
Make sure that the capacitive
switch module is powered up.
B.
Capacitive switch plate is
disconnected.
B.
Make sure that the ring terminal is
connected to the capacitive switch
plate.
C.
Capacitive switch module does
not work.
C.
Replace the capacitive switch
module.
3.
One LED light
does not
illuminate.
A.
LED light is disconnected.
A.
Make sure the LED light is
plugged in.
B.
LED light does not work.
B.
Replace the LED light.
C.
Capacitive switch module is does
not work.
C.
Replace the capacitive switch
module.
4.
Task lighting does
not turn on.
A.
Power is not being drawn from
the outlet.
A.
Plug the cord into the 110 V AC
outlet.
B.
Lamp is burnt out.
B.
Replace with 13 W, 21
″
(53.3 cm)
T5 bulbs.
C.
Cable is disconnected.
C.
Verify that the cable on the bottom
of the pull-out is plugged in.
D.
Wires are improperly connected.
D.
Access the wiring to verify the
wiring is correct.
E.
Lamp does not work.
E.
Replace with 13 W, 21
″
(53.3 cm)
T5 bulbs.
1059686-5-D
8
Kohler Co.