1. Prepare the Handshower Bracket
NOTE:
This accessory should not be installed in the area 24
″
(61 cm)
to 48
″
(121.9 cm) from the floor (the critical support area as defined
in ASTM F446).
Position the bracket on the finished wall, and mark the top and
bottom hole locations.
Drill a 3/16
″
hole through the tile only to mount directly to a
stud.
If a stud cannot be located, drill a 3/8
″
hole.
2. Install the Anchors
Press and hold the legs of a wall anchor (provided) together and
insert the wall anchor legs into the hole. Insert a wall anchor into
each pre-drilled mounting hole.
With a hammer, carefully tap each wall anchor until they are
flush with the finished surface.
If the wall anchor was inserted into a space between the studs, it
will be necessary to spread the wall anchor legs.
To spread the anchor legs, insert a thin long object, such as a
finishing nail, into the wall anchor hole.
Nail
Install the Anchor
Kohler Co.
3
1045302-2-B
