Kohler GM31994-KP1, Инструкция по установке

Страница: 3 / 4

TT-1375 4/12 3
Note:
Bleed the fuel system according to the
generator set operation manual. If air is
trapped in the fuel system, the engine will
be difficult to start and/or engine operation
will be erratic.
4. Draining the water.
At the interval specified in the generator set operation
manual, drain water from the fuel/water separator. Hold
a suitable container beneath the fuel/water separator
and push up on the drain valve. See Figure 3. Release
the valve when fuel (free of water) flows from the
fuel/water separator.
1
GM32181
1. Air bleed screw
2. Drain plug
3. Drain valve
2
3
Figure 3
Fuel/Water Separator
5. Changing the element.
At the interval specified in the generator set operation
manual, replace the water separator element using the
following procedure.
5.1 Close the fuel valve at the nearest point to the
water filter inlet or at the fuel tank.
5.2 Remove the water drain plug (or push up the drain
valve) and allow water and fuel to flow into a
suitable container.
Note:
Depending upon the location of the fuel valve, a
considerable amount of fuel may drain out.
5.3 Remove the water separator element from the
mounting head by twisting in a counterclockwise
direction.
5.4 Remove the bowl from the fuel/water separator
element. Wipe the excess fuel from the bowl and
the O-ring. Do not discard the bowl or O-ring.
5.5 Inspect the components for wear or damage.
Replace parts as necessary.
5.6 Lubricate the O-ring with clean diesel fuel and
replace it in the bowl.
5.7 Install the bowl onto a new fuel/water separator
filter element.
Note:
Kohler service replacement fuel/water separator
element part number is GM41014.
5.8 Lubricate the bowl/element assembly with clean
fuel.
Install the bowl/element onto the filter
mounting head.
5.9 Replace the water drain plug (if removed) and
close the vent.
5.10 Remove the air bleed screw from the fuel/water
separator.
5.11 Open the fuel supply valve.
5.12 After fuel fills the water separator, allow fuel to flow
from the air bleed hole until all air is displaced (fuel
flows free of air bubbles).
5.13 Replace the air bleed screw.