Remove the old gasket from the floor
and the closet flange with a putty knife.
Remove the old T-bolts and discard
them.
f the new toilet is not
installed immediately, temporarily stuff
a rag into the closet flange.
NOTICE: I
T
Fig.#2
2
Closet Flange
TO REMOVE EXISTING TOILET
Turn off the water supply. Flush the toilet, and use a sponge
to remove the remaining water from the tank and bowl.
Disconnect the supply shut-off valve (if present), and remove
the old tank and bowl.
(
)
INSTALLATION
TO INSTALL SUPPLY
SHUT-OFF VALVE
Install the supply shut-off valve so it
is127mm above the finished floor line,
and 130mm to the left of the closet
flange centerline.
The centerline of the supply shut-off
valve outlet should extend 70mm from
the finished wall. Install the supply
shut-off valve with the outlet vertical.
127mm
130mm
70mm
Fig.#4
4
Supply Shut-Off Valve
Closet Flange
Centerline
130
305
127
Install two new 8mm (5/16") diameter
T-bolts into the closet flange.
Do not use white cement or
high lime content cements to install
this toilet. The expansion of cement
due to a rise in temperature may make
the toilet crack or cause damage.
Kohler is not responsible for any
damage caused by installation with the
use of cement.
NOTICE:
8mm
T
Fig.#3
3
Closet Flange
T-bolts
T
-3-
1176009-T01-A
