1269145-AN2-A
2
1269145-AN2-A
3
INSTALLATION CHECKOUT
Ensure that all connections are tight.
Turn on the drain and main water supply and check
for leaks. Repair as needed.
Remove the handspray(15). Run hot and cold water
through hose(13) for about one minute to remove any
debris. Remove any debris from the handspray. Shut
off the main water supply. Reinstall the handspray.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
INSTALLATION
①
②
How to Install the Slide Bar
Decide on a suitable position for the slide bar
avoiding buried cables and pipes in the wall.
Mark the wall fixing hole positions for the top
of the slide bar and drill two holes to suit the
bracket(1). Insert anchors(2) into the holes.
Fix bracket(1) to wall using screws(3).
Rehearse installation of the slide bar using
screws(5), slide bar(4) and lower bracket(8).
Mark the outline of the lower bracket on the
wall and find the position of the holes. Drill
two holes to suit the lower bracket. Insert
anchors(2) into the holes.
Fix lower bracket(8) to the wall using
screws(3).
Slide the handspray holder(9) onto the bar(4).
Adjust the holder to the proper position.
Tighten the slide bar kit with screws(5).
Slide the bracket covers(6) onto the bracket,
and install the slide bar end covers(7).
How to Install the Elbow and Handspray
NOTE:
To perform installation the installer
must provide a G1/2" water supply nipple(10).
Distance from the end of the nipple to the
finished wall surface should be between 10
and 13mm and perpendicular to the wall.
Apply tape or thread sealant to the threads of
the water supply nipple.
Apply a ring of plumber’s putty or sealant
around the back surface of the elbow(11).
Thread the elbow onto water supply nipple.
Adjust and make sure the outlet(12) faces
down.
Tighten hose(13) with seals(14) to elbow
outlet and to handspray(15).
Hang handspray on handspray holder(9).
1
3
5
4
9
6
6
7
7
5
2
8
3
2
14
12
12
15
13
10~13mm
10
11
15
13
