-5-
1051705-T01-A
2) For Two Door
Drill three 3/16 holes in bottom mounting bar at indent
location. Use the supplied anchors or locate studs if possible.
2)
5
K-15030T-NA
K-15034T-NA
K-15035T-NA
4 1/2" from edge side of cabinet
114
2" from edge side of cabinet
50
3/4 bottom of Cabinet
20
Fig. 3
3
Fig. 4
4
2" from edge side of cabinet
50
3/4 bottom of cabinet
20
K-15030T-NA
3) Drill 1/4 hole in wall for mounting bar anchors at locations
shown in Fig.3.(If you do not use the anchor, drill a 3/32
pilot hole.) After the holes are drilled, fit the mounting bar
onto the wall, refer to Fig. 3 for measurements, and Fig. 5
for information on anchor cinching.
3)
3
7
(
2
)
3
5
B.
(
)
1)
7A
2)
7B
3)
7C
,
4)
8
5)
B. Install Top Clips
(Left and right top clips come connected, hold both clips
and snap them apart).
1) Fit cabinet into position on mounting bar as shown in
Fig.7A.
2) Place clip in position as shown in Fig.7B and mark with a
pencil. Remove clip and cabinet and drill the pilot or
anchor holes where marked.
3) Fix both the clips into position with a screw, and slide the
clip into the up position. Sit the cabinet on the mounting
bar, then lower and tighten the screws into place, as
shown in Fig 7C.
4) See Fig. 5 on next page for proper turns required for
anchor cinching.
5) See page 7 for Side Kit Mirror application.
1056564-T01-A
