Kohler COUTURE WATERGUARD, Руководство по установке

Страница: 1 / 8

110282-2-
AA
(9515)
Copyright 1996 Kohler Co.
COUTURE

WATERGUARD
VITREOUS CHINA
SIPHON JET TOILET
1. BEFORE YOU BEGIN
HOW TO USE THESE INSTRUCTIONS
Please read these instructions carefully to familiarize
yourself with the required tools, materials, and installation
sequences. Follow the sections that pertain to your
particular installation. This will help you avoid costly
mistakes. In addition to proper installation, read all
operating and safety instructions. All information in these instructions is based on the latest
product information available at the time of publication.
Kohler Co. reserves the right to make changes in product
characteristics, packaging, or availability at any time
without notice.
These instructions contain important care, cleaning, and
warranty information – please leave for the consumer.
INSTALLER HAZARD NOTIFICATION
WARNING: Risk of injury or product damage.
Handle vitreous china products very carefully.
Vitreous china can break and chip if you overtighten
bolts and nuts.
NOTE: Follow all local plumbing codes.
PRODUCT PROPERTIES
Distance from the rim to the water surface is 4-7/8”.
2-1/4” passageway.
For roughing-in and overall dimensions, see
Fig. #1.
Fixture dimensions are nominal and conform to
tolerances by ANSI standards (A112.19.2).
PRODUCT REQUIREMENTS
Since all toilets do not have the same supply
rough-in, you may have to change the location of
the supply stop to install this toilet.
Closet flange must be 12” on-center from wall.
Seat post holes are on 5-1/2” centers.
This toilet is designed to flush using 3.5 gallons
when the tank refill time is adjusted to between 50
and 55 seconds. Tank refill time is measured from
the moment the flapper ball reseats to the time
water stops flowing through the refill tube. Slightly
longer refill time may be necessary to compensate
for permanent or temporary low water pressure. To
adjust the refill time, see “To Adjust Refill Time”,
on Page 5.
ORDERING INFORMATION
Couture

Waterguard Toilet K-3470-C . . . . . . . . . . . . . . .
When specified:
3/8” supply K-7638 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Floor bolts (pr.) 21401 . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTE: For service parts ordering information, see
separate Service Parts document enclosed with the
product.
MATERIALS REQUIRED
Closet flange
Toilet gasket (wax seal)
Toilet T-bolts (2) 5/16” diameter
Toilet setting compound (optional)
Toilet supply shut-off valve, 3/8” required
TOOLS REQUIRED
10” adjustable wrench
12” pipe wrench
Screwdriver
Tape Measure
Tubing cutter
Level
Putty knife
Hacksaw/metal file (for shortening T-bolts)
NOTE: Site preparation may require additional tools.