Kohler Command PRO CS, Руководство по обслуживанию

Страница: 130 / 162

Section 11
Reassembly
11.2
Figure 11-4. Installing Governor Shaft. Figure 11-2. Installing Bearing in Closure Plate.
3. Use a seal driver and install the crankshaft oil
seals (manufacturer’s numbers visible) into
crankcase and closure plate. Seals should be
installed to a depth of 2 mm (0.080 in.) below
outer surface. See Figure 11-3. Apply a light
coating of lithium grease to seal lips when
installing.
Figure 11-5. Installing Outer Washer.
3. Install the second flat washer onto the shaft.
Position the shaft so the lower flat section faces to
the right (3 o’clock position) and insert the hitch
pin so the end of the clip comes in contact with
the raised section of the housing boss, limiting
the inward movement of the arm. See Figures
11-6 and 11-7.
NOTE: Verify that correct installation has been
made at this time.
Figure 11-3. Installing Oil Seal.
Install Governor Cross Shaft
1. Install the governor shaft seal, with the
manufacturer’s marks out, into the governor shaft
bore in crankcase until flush with the top. A 1/2
in. O.D. seal driver or round stock may be used to
install.
2. Install one thrust washer onto the governor cross
shaft and slide the shaft up through the inside of
the crankcase.
Grease
2 mm
(0.08 in.)