1248999-2A-C
2
1248999-2A-C
3
INSTALLATION CHECKOUT
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
CLEANING INSTRUCTIONS
INSTALLATION
How to Install the Faucet
Shut off water supply. Cut away the
extending part of the base protector(1)
in accordance with the tile surface.
Remove plug(2) from the base.
Remove protector(3) from the faucet.
Slide up escutcheon kit(4). Install the
faucet.
NOTE:
Keep the faucet vertical
to base, to avoid damaging the O-rings
on the bottom.
Keep the spout pointing to tub. Fix the
faucet to the base with screws(5) and
washers(6) through flange(7). Tighten
the screws with hex wrench(8).
Slide down the escutcheon kit, make
sure it against the finished wall.
Ensure that all coupling nuts are tight.
Ensure that the handle is in the off
position.
Turn on the main water supply, and
check for leaks. Repair as needed.
Remove the aerator(14) by key(13).
Remove the handshower(11). Turn on
faucet handle. Run hot and cold water
through spout for about one minute to
remove any debris. Check for leaks at
this time. Remove any debris. Shut off
the faucet. Reinstall the aerator and
handshower.
How to Install the Handshower
Remove the protector from diverter
kit(9).
Connect hose(10) to diverter kit and
handshower(11) with washers. Tighten
all the connections.
Hang the handshower on the
bracket(12) of the faucet.
HANDLE OPERATION
Lift handle gently. Turn clockwise for hot water, counter-clockwise for cold water.
Lift and turn the diverter for handshower. Turn the diverter in the normal position for bath spout.
14
13
11
8
10
11
12
9
2
1
3
7
5
6
4
