3
106965-2-
AA
(B)
Kohler Co., Kohler, WI
VALVE BODY/TEE INSTALLATION
Attach hose to each valve body and tighten. Slide gasket
over top of valve body, and thread on the escutcheon.
Place valve body assembly through sink with hot valve
(marked red) on left side and secure with washer and nut.
Connect hose to shank tee and tighten. Repeat for cold
valve.
Escutcheon
Valve
Body
Hose
Nut
Washer
Shank
Tee
Gasket
HANDLE INSTALLATION
Rotate valve stem to closed position and slide spline
adapter over valve stem.
Unthread outer shell from skirt assembly, by firmly holding
outer shell and turning skirt assembly clockwise.
Remove insert from rubber holder in skirt assembly.
Fasten skirt assembly to valve stem with screw.
Snap insert into rubber holder in skirt assembly.
Thread outer shell onto skirt assembly, by firmly holding
outer shell and turning skirt assembly counterclockwise.
Skirt Assembly
Screw
Insert
Outer Shell
Valve Stem
Spline Adapter
SUPPLY INSTALLATION
If kitchen sink is not installed, install at this time.
Ground joint: slip nut onto supply tube. Carefully position
round end of supply tube squarely to valve inlet and
supply stop. Tighten all nuts.
Valve Inlet
Nut
Supply Tube
Supply Stop
