1289697-2A-A
2
1289697-2A-A
3
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
INSTALLATION
INSTALLATION CHECKOUT
10
8
4
3
1
2
5
6
7
9
How to Install the Handle Kit
Install the washer(2) into the groove of the
handle kit(1). Insert the handle kit with washer
to the mounting hole. Adjust the handle. Make
sure the handle with red dot is on the left side
and blue dot on the right side.
Install the screws(7) into the threaded ring(6).
From underside, slide the washer(4) and
washer(5) to the body(3). Screw the threaded
ring. Tighten the screws to secure the handle
kit.
Attach the two hoses(8) to water supplies.
When facing front of the faucet, the left hose
connects to hot water, the right hose with
“COLD” label should be connected to cold
water. Connect the rear hose(9) and the hose
assembly(10).
How to Operate the Handshower
Press the buttons of the handshower to
change the water flow.
Ensure all coupling nuts are tight. Turn on
main water supply and check for leaks. Repair
as required.
10
11
15
16
12
14
17
18
19
20
13
How to Install the Handshower
Adhere the washer(15) to the bottom of the
escutcheon(14). Screw the escutcheon to the
shank(16). Place the shank into the mounting
hole until the escutcheon against the deck.
Install the screws(20) into the fixing ring(19).
From underside, slide the washer(17, 18) to
the shank. Screw the fixing ring. Tighten the
screws to secure the shank.
Slide the hose(13) through the escutcheon,
and attach to the other end of the hose
assembly(10).
Install the restrictor(12) into the inlet of the
handshower(11) if needed. Connect the
hose(13) and handshower.
How to Maintain the Handshower
Any debris or mineral build-up may cause the
flow stream to become distorted or reduce the
flow rate. To remove the debris or mineral
build-up, run water through the handshower,
firmly press or rub your finger back and forth
across the rubber nozzles.
Remove and clean the screen washer.
Katalyst Air
Intense Massage
